D7- RS232 Serial Port setup
- Download the Serial Port Debug Assistant (Windows)
- Connect the serial line (EG:9 PIN). For the first time use, you need to install the USB driver. Otherwise, Pin 2 is TXD; Pin 3 is RXD.


- Below are the Serial Port Configuration settings.
Setting name
Value
Baud Rate
115200
Data Bits
8
Stop Bits
1
Check Bit
None
1. Next, go to the Device Manager, right-click to view the properties and view the Port Settings

2. Enter the Serial Port Configuration settings (above) and click OK
1. Open the Serial Port Debug Assistant, fill out the Serial Port, Baud Rate, Data Bits and Stop bits
2. Check HEX display under both, Receive settings and Send settings
3. Open the Serial port
4. Copy & Paste any of the codes from the table below into the empty field and click the “Send” button.
Discrete Codes (v1.3.4)
Source Select PC (ZOOM)
FE 60 00 24 00 AA
Source Select VGA
FE 60 00 21 00 AA
Source Select HDMI 1
FE 60 00 23 00 AA
Source Select HDMI 2
FE 60 00 43 00 AA
Source Select DP
FE 60 00 63 00 AA
Volume Up
99 01 17 01 E8 AA
Volume Down
99 01 18 01 E7 AA
Audio Mute On
99 01 02 01 FD AA
Audio Mute Off
99 01 02 01 FD AA
Display On
99 A2 01 01 27 AA AA AA
Display Off
99 01 05 01 FA AA