BIRDDOG - Use IPV6 Protocol To Access A BirdDog Device USE IPV6 PROTOCOL TO ACCESS A BIRDDOG DEVICE DOCUMENT SUPPLIED BY BLONDE ROBOT PTY LTD, FOLLOW INSTRUCTIONS AT OWN RISK 1. Find the MAC address of the device, there will be a label somewhere on your device with the MAC address, it will be in the format XX:XX:XX:XX:XX:XX Here is an example from an A200 camera: 2. The IPv6 protocol MUST be turned on for the network port you are using to connect to the same network. Here is an example from Windows 10: 3. Paste the MAC address, including colons, into the MAC address field found at the following site: MAC to IPv6 Converter = https://nettools.club/mac2ipv6 EXAMPLE MAC = 80:1f:12:34:88:e3 4. This will then convert your MAC address into an IPv6 address, copy this new IPv6 address into the clipboard. 5. Go to your browser and type http://[ then paste the new IPv6 address and add a closing square bracket ]. For example: http://[fe80::821f:12ff:fe34:88e3] This should then take you to the web interface of your device: 6. Enter your password and you should now be able to access the IP settings and change them as needed.